Aastra Telecom AastraLink RP 500 - Manual (Page 10)

4 AastraLink RP 500 Installation Guide
Setting Up Your System
Setting Up Your System
The AastraLink RP 500 can be wall-mounted or placed on a desktop.
Wall-Mounted Unit
The template, screws, and anchors from the wall-mounting kit are used to
mount the AastraLink RP 500 on the wall. The bottom of the unit should be
against the wall when mounted.
1. Use the provided template to mark locations for mounting screws.
2. Drill holes at marked locations and install anchors.
3. Apply screws to anchors.
4. Align the AastraLink RP 500 on the screws.
Desktop Unit
Place the AastraLink RP 500 on a flat surface.
Connecting to Power and the Local Area Network
1. Plug one end of the Ethernet cable into the Local Area Network (LAN
and the other into the AastraLink RP 500 Ethernet jack .
2. Connect the power cord to the AastraLink RP 500 power jack , and
plug the other end into an electrical outlet.
Confirm that all cables and cords are properly seated into their respective
ports and outlet.
You are now ready to setup the other components of the AastraLink RP
system, following the appropriate Installation Guides.
AastraLink RP 500 Base Unit
Local Area Network (LAN)
Power