LG 55LA9700 - Manual (Page 33)

MAGIC REMOTE CONTROL FUNCTIONS
ENGLISH
33 MAGIC REMOTE CONTROL FUNCTIONS
MAGIC REMOTE CONTROL FUNCTIONS
When the message “Magic remote control battery is low. Change the battery.” is
displayed, replace the battery. To install batteries, open the battery cover, replace
batteries (1.5 V AA) matching and ends to the label inside the compartment,
and close the battery cover. Failure to match the correct polarities of the battery
may cause the battery to burst or leak, resulting in fire, personal injury, or ambient
pollution. Be sure to point the remote control at the remote control sensor on the
TV. To remove the batteries, perform the installation actions in reverse.
y Do not mix old and new batteries, as this may damage the remote control.
This remote uses infrared light. When in use, it should be pointed in the direction of the TV’s remote
sensor.
SMART
Accesses the Smart Home menu.
VOL
Adjusts the volume level.
CH
Scrolls through the saved channels.
(MUTE)
Mutes all sounds.
Navigation buttons
(up/down/left/right)
Scrolls through menus or options.
Registering Magic Remote Control
The Magic Remote Control operates by pairing
with your TV.
Please register the remote as follows.
How to register the Magic Remote Control
(Wheel)
To register automatically, turn the
TV on and press the Wheel (OK).
When registration is completed, the
completion message appears on the
screen.
If registration fails, turn the TV off
and back on, then press the
Wheel (OK) to complete registration.
How to Re-register the Magic Remote Control
BACK
SMART
1 Press and hold the BACK and
SMART buttons together for 5
seconds to reset, then register it
by following How to register the
Magic remote control above.
2 To re-register the Magic remote
control, press and hold the
BACK button for 5 seconds toward
the TV.
How to use Magic Remote Control
1 You can move the pointer by
aiming the Pointer Receiver of the
remote control at your TV then
move it left, right, up or down.
» If the pointer does not work
properly leave the remote control
for 10 seconds then use it again.
2 If the pointer disappears, move
the remote control slightly to left
or right. Then, it will automatically
appear on the screen.
» If the pointer has not been used
for a certain period of time, it will
disappear.
1
If you press Wheel (OK) on the
Magic remote control, the screen
appears.
Shows information about the current
program and screen.
2 You can select My Apps Menu.
Precautions to Take when Using
the Magic Remote Control
y Use the Magic remote control within the
maximum communication distance (10 m,
32.8 ft). Using the remote control beyond this
distance, or with an object obstructing it, may
cause a communication failure.
y A communication failure may occur due to nearby
devices. Electrical devices such as a microwave
oven or wireless LAN product may cause
interference, as these use the same bandwidth
(2.4 GHz) as the Magic remote control.
y The Magic remote control may be damaged or
may malfunction if it is dropped or receives a
heavy impact.
y Take care not to bump into nearby furniture or
other people when using the Magic remote
control.
y Manufacturer and installer cannot provide
service related to human safety as the applicable
wireless device has possibility of electric wave
interference.
y It is recommended that an Access Point (AP) be
located more than 1 m (3.28 ft) away from the
TV. If the AP is installed closer than 1 m (3.28 ft),
the Magic remote control may not perform as
expected due to frequency interference.