LG VS910 - Manual (Page 18)

16
The Basics
Installing the Battery and microSD Card
NOTE It is important to fully charge the battery before initial use of the phone.
Installing the battery
The phone comes with a rechargeable battery. Keep the battery charged
while not in use in order to maximize talk, use, and standby time. The
battery charge level is shown at the top right corner of the screen.
Removing the battery
Turn the power off. Remove the battery cover (as demonstrated in the previous
instructions). Then flip the phone to its normal position and use the fingertip
cutout at the top left corner of the battery compartment to lift the battery out.
Inserting a microSD card
Turn the power off. Remove the battery cover and the
battery (as demonstrated in the previous instructions).
Locate the microSD card slot (microSD is inscribed
near the slot opening). Position the microSD card with
the label side facing up and slide it into place until it is
fully inserted and locked in place.
1 Hold the phone with
both hands, with the
microphone facing
upward. Then use
the fingertip cutout
to pull open the back
cover (as shown
above).
2 Align the battery
contacts with
the terminals
at the bottom
of the battery
compartment, then
press the battery
into place.
3 Replace the battery
cover over the back
of the phone (as
demonstrated).
Apply a steady
downward pressure
until the back cover
clicks into place.