LG LP0910WNR - Manual (Page 10)

USING THE CONTROLS
Control panel buttons shown. Operation using the remote control is the same, unless
specifically noted.
1. COOLING MODE
· Press MODE button to choose Cool
mode, the Cool mode indicator will flash.
· Press UP or DOWN button to set room
temperature between
.
· Press FAN button (or High/Low button)
to select high, low fan speed.
2. FAN MODE
· Press MODE button (or Fan button) to
choose Fan mode, the Fan mode indicator
will flash.
Select the fan speed by press FAN button
or press High / Low button directly.
· The temperature can not be set.
62 F to 86 F
NOTE
Always point the remote at the sensor. The remote may not work if the
sensor is in bright light or if there is not a clear path between the remote
and the sensor.
10
After setting continuous，the unit will keep
running no matter what temperature it sets,
and E4,E1,E2 protection works.
5. CONTINUOUS
·
3. TIMER MODE
· When the appliance is switch off, press
TIMER button to set timer-on.
· Press Up or Down button to adjust time
from 1 hour to 24 hours. The Time
on indicator will flash.
· When the appliance is running, press
TIMER button to set timer-off.
· Press Up or Down button to adjust time
from 30 minutes to 24 hours. The Time
off indicator will flash.
Setting sleep mode, the temperature
will rise 1 after 2 hours, and another 2
hours later, rise 1
· Then it will keep steady and low fan blow.
4. SLEEP MODE
·
· High fan blows.
Press MODE button to choose Dry mode,
the Dry mode indicator will flash.
6. DRY MODE
·
· Under Dry mode, don’t install exhaust hose,
take out the drain plug, and lead the condensing
water to the container through water pipe.
· When first enter the Dry mode, if Ta≥59℉，
the compressor starts; if Ta≤55℉, the
compressor stops; for other conditions, it keeps
the state as before.
· Under Dry mode, fan motor acquiesces in
low speed. The fan speed cannot be changed;
· Under Dry mode, the setting temperature is
invalid, and it indicates the ambient
temperature(50℉~95℉).