LG LRG3091ST - Manual (Page 17)

ENGLISH
17
OPERATING INSTRUCTIONS
USING THE CLOCK AND TIMER
HOW TO SET THE CLOCK
The clock should be set to the correct time of day for the
automatic oven timing functions to work properly. The
time of day cannot be changed during cooking or self-
clean mode.
ᕡ Press the CLEAR OFF pad.
ᕢ Press the CLOCK pad.
ᕣ Press the + or – pad to set the time of day.
ᕤ Press the START pad.
The clock will be set, and the display will
reflect the change after a short delay.
ᕡ Press the TIMER ON/OFF pad once to set
the time in minutes and seconds, OR press
the pad twice to set the time in hours and
minutes. TIMER will flash in the display.
ᕢ Press the + or - pad until the desired time
appears in the display.
ᕣ Press the TIMER ON/OFF pad to start the
countdown. TIMER will show in the display.
NOTE: If TIMER ON/OFF is not pressed, the
timer will return to the time of day.
ᕤ When the timer reaches :00, End will show
in the display. The clock will sound with 3
beeps every 15 seconds until the
TIMER
ON/OFF pad is pressed.
HOW TO SET THE TIMER
The TIMER ON/OFF serves as an extra timer in the
kitchen that will beep when the set time has run out. It
does not start or stop cooking or control oven operations.
The
TIMER ON/OFF feature can be used during any of
the other oven control functions.
NOTE:
1. If you press
TIMER ON/OFF once, it allows you to set
the time in minutes and seconds.
(For example: if you press 50,
it means 50 seconds.)
2. If you press TIMER ON/OFF twice, it allows you to set
the time in hours and minutes.
(For example: if you press 5,
it means 5 minutes.)
HOW TO CHANGE THE HOUR MODE ON
THE CLOCK (12 HR OR 24 HR)
Your control is set to use a 12 hour clock. If you would
prefer to have a 24 hour time clock, follow the steps
below.
ᕡ Press the CLOCK pad for three seconds.
ᕢ Press the CLOCK pad to switch between
the 12 hr clock and the 24 hr clock.
ᕣ Press the START pad to accept the desired
change.
NOTE: If the remaining time is not in the display, recall
the remaining time by pressing the
TIMER ON/OFF.
HOW TO CANCEL THE TIMER
Press the TIMER ON/OFF pad. The display will return to
the time of day.
POWER OUTAGE
If a flashing time is in the display, you have experienced a
power failure. You will need to reset the clock time.
Press the
CLOCK pad once to reset. Enter the correct
time of day by pressing the + or - pads.
Press the
START pad.
ENGLISH