LG 42CQ610H User Manual
Page 7
7
ENG
ENGLISH
TABLE OF CONTENTS
Additional Information
The Owner’s Manual and Commercial Mode
Setup Guide contain detailed information on the
advanced features of these TVs. To view the
extended documentation, visit our website at:
www.lgsolutions.com/products. From the Products
page, select TVs, Systems & Solutions, then LCD
TVs, then the applicable TV. Click the Literature
& Downloads tab at the bottom of the TV page,
and select the required document(s) from the
Downloads list.
TABLE OF CONTENTS
2
LICENSES
3
IMPORTANT SAFETY INSTRUCTIONS
7
TABLE OF CONTENTS
7
Additional Information
8
INSTALLATION PROCEdURE
8
ASSEMBLING ANd PREPARING
8
Accessories
9
Protection Cover
10
Rear Jack Panel
13
Wall Mount Installation
14
Setting Up the TV
14
- VESA Wall Mounting
15 GENERAL TROUBLESHOOTING
17
OPEN SOURCE SOFTWARE NOTICE
FCC NOTICE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation of the device.
Any changes or modifications in construction of this device which are not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.