Atech Tech LIBRA-02 HM - Manual (Page 21)

21
Operating and Safety Instructions
12. TROUBLESHOOTING
Here are some recommendations for solving urgent problems. If the trouble cannot be
solved, or if you have a problem other than those described hereunder, please contact
our technical service or your nearest dealer.
TROUBLE CAUSES REMEDY
Not cooling the router bit
surfaces
Lubricate the surfaces of the router bit,
Use of cooling liquid
Low surface quality (at
aluminum and similar
materials) :
Rough surface,
Large chip,
Not homogenous
surface
Damaged or blunt router
bit use
Check the tip of the router bit and its
cutting flutes, the tip could be broken. If so,
replace the router bit.
Motor does not work
(although the start
button on the lever is
kept pressed) There is no power supply to
the machine Check the electric connections.
Check the power sockets.
Motor runs, but the
pneumatic clamp
pistons do not work.
The air supply connections
are missing or faulty. Check the air compressor connections
Adjust the air pressure to 6-8 Bar on the
conditioner
The router bit rotates in
reverse direction.
The electric connections,
power cable or control
panel connection is wrong Let the electric connections carry out by a
qualified electrician.