LG LP0814WNR - Manual (Page 11)

CONTROL PANEL AND REMOTE
POWER
Press the POWER button to turn the air conditioner
ON or OFF. Any control settings such as Cool, Dry,
Fan, and Fan Speed will be retained in memory when
the power is off. When turned on after being
unplugged, the air conditioner will automatically
reset. Any settings will need to be re-entered.
MODE
Press this button to select the operating mode such
as Cool, Dry (Dehumidify), or Fan for the air conditioner.
And you can see the active mode through the
indicator lights. The default setting is Cool. Press the
MODE button to change to Dry (Dehumidify), press
again to change to Fan, and again to change to Cool.
FAN
Adjusts the circulation fan speed between High and
Low fan speed. The selected fan speed will be
shown through the indicator lights. The function can
be used in Cool and Fan modes. When changing
fan speeds, there is a brief delay before the fan
motor changes speed.
Operation of functions is the same when using the remote
or the control panel, unless otherwise stated.
11
NOTE:
The remote sensor is located under the LED display.
Point the remote anywhere at the sensor. The remote may
not work if the sensor is in bright light or if there is not a
clear path between the remote and the sensor.
TIMER 4
When the TIMER function is selected, you can set
the air conditioner to either automatically turn
OFF or turn ON after a delay of up to 24 hours.
The display will show 0. Use the buttons
to adjust the delay time from 1 to 24 hours, in one
hour increments.
To set an automatic off delay, press the TIMER
button while the air conditioner is running and
use the buttons to adjust the delay time.
air conditioner will automatically turn off after the
set delay.
To set an automatic on delay, press the TIMER
button while the air conditioner is off and use
the buttons to adjust the delay time.
The display will show the number of hours
remaining until the unit is set to come on. The
air conditioner will automatically turn on after
the set delay.
If you want to know how many hours you have
setted, press the TIMER button and then you
can see the time through the LED display.
If you want to change the set timer, press the
TIMER button and adjust the time when the
number is flickering.
To cancel the Timer function, press the TIMER
button and adjust the number to 0 when the
number is flickering, then the function will be
canceled in a few seconds.
Another better method is press the TIMER
button and press this button again when the
number is still flickering.
1
2
5
2
8
8
1
3
4
7
Timer
1
2
3
6
4
H O W T O U S E
COOL Compressor runs and cools the room. Use the
/ and FAN buttons to set the desired
temperature and circulation fan speed.
FAN Fan circulates air but compressor does not run.
Use the FAN button to set the desired fan speed.
DRY Dry mode is used to remove humidity from
the room without additional cooling.
Fan speed is pre-set and cannot be adjusted.
Mode Features
English
3
5