LG LSC24971ST - Manual (Page 12)

12
ENGLISH
Installation
Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the refrigerator door and pass the
refrigerator laterally.
Remove 2 screws holding the lower cover in place. Pull up the feed water tube while
pressing area
shown in the figure to the right.
Remove lower
cover and
then feed water
tube
Remove the
freezer
compartment
door
Remove the
refrigerator
compartment
door
1) Removing the hinge cover by loosening
the screws. Separate all connection wires
except for the earth line after.
2) Remove the keeper by rotating it counter
clockwise ( ) and then lifting the upper
hinge up ( ).
3) Remove the freezer compartment door by lifting
it upward. This time, the door should be lifted
enough for the feed water pipe tube to be
completely pulled out.
1) Loosen the hinge cover screws and
remove the cover. Remove connection
wire, if any, except for the earth line.
2) Remove keeper by rotating it clockwise
( ) and then remove the upper hinge
by lifting it up (
).
3) Remove the refrigerator compartment
door by lifting it up.
• If a tube end is deformed or abraded, cut the part away.
NOTE
• When removing the upper hinge, be careful that
the door does not fall forwards .
NOTE
• Move the freezer compartment door passing through the access door and lay it
down, but be careful not to damage the feed water pipe tube.
NOTE
Lower cover
Lower hinge
Lower hinge
Keeper
Feed water tube
Connection
wires
Hinge
cover
Upper hinge
Keeper
Upper hinge
Ground Line
Upper hinge
Connection
wires
WARNING