APPLIED ENGINEERING RamWorks 2 MEG Plus Memory Expander - Manual (Page 3)

Installing the 2 MEG+
- - First, TURN OFF THE POWER SUPPLY.
- - Remove the cover from your IIe.
- - Discharge any static electricity on your body by
touching the IIe power supply case before touching
any of the components.
* Warning! Don’t ZAP your chips! There are many
static sensitive components in the IIe and on the
RamWorks and 2 MEG+ Memory Expander cards. Be
sure that you touch the power supply case before
continuing.
- - Remove the RamWorks card.
- - Carefully line up the pins on the underside of the 2
MEG+ Expander with the corresponding sockets on
the chip side of the RamWorks card. Refer to the
illustration below.
-- Press the pins gently but firmly into the sockets until
they are fully seated. (Even when it's fully seated
there may still be some of the pin showing between
the connectors, so don’t press too hard!)
1