LG LDS5774ST - Manual (Page 32)

32 SMART DIAGNOSIS™ SYSTEM
SMART DIAGNOSIS™ SYSTEM
Should you experience any problems with your dishwasher, it has
the capability of transmitting data to your Smart Phone using the
LG Smart Laundry & DW Application or via your telephone to the
LG call center. Smart Diagnosis cannot be activated unless your dishwasher is
turned on by touching the POWER button. If your dishwasher is
unable to turn on, then troubleshooting must be done without
using Smart Diagnosis.
Smart Diagnosis Through the Call Center
1. Call the LG call center at: (LG U.S.) 1-800-243-0000
(LG Canada) 1-888-542-2623.
2. When instructed to do so by the call center agent, hold the
mouthpiece of your phonenear the hole located on the side
panel. Hold the phone no more than one inch (but not touch-
ing) the machine.
Do not touch any other buttons or icons on the display
screen.
NOTE
3. Press and hold the Rinse button on the display screen for
three seconds.
4. Keep the phone in place until the tone transmission has fin-
ished. This takes about 6 seconds and the display will count
down the time.
5. Once the countdown is over and the tones have stopped, re-
sume your conversation with the call center agent, who will
then be able to assist you in using the information transmit-
ted for analysis.
Smart Diagnosis Using Your Smart Phone
1. Download the LG Smart Laundry & DW application on your
smart phone.
2. Open the LG Smart Laundry & DW application on your smart
phone.
3. Press the Smart Diagnosis button on your smart phone.
4. Press the Diagnose button on your smart phone.
5. Press the Dishwasher button on your smart phone.
6. Press the RECORD button on the smart phone and then hold
the mouth piece of the smart phone near the speaker located
on the side panel. Hold the phone no more than one inch
(but not touching) the machine.
7. Press and hold the Rinse button on the dishwasher display
for three seconds.
8. With the phone held in place, press the Smart Diagnosis
button on the phone.
9. Keep the phone in place until the tone transmission has fin-
ished. This takes about 17 seconds and the display will count
down the time.
10. When the recording is complete, view the diagnosis by press-
ing the Next button on the phone.
After three seconds, the display will change from 0:22 to
17 and then start counting down the remaining time.
NOTE
Do not touch any other buttons or icons on the display
screen.
NOTE
Smart Diagnosis is a troubleshooting feature designed to as-sist, not
replace, the traditional method of troubleshooting
pends upon various factors,
including, but not limited to, the reception of the cellular phone being
used for transmission, any external noise that may be present during
the transmis-sion, and the acoustics of the room where the machine is
lo nosis
would accurately troubleshoot any given issue.
NOTE
(LDF**** ) (LDS**** )