LG LP1014WNR - Manual (Page 12)

CONTROL PANEL AND REMOTE
1
8
English
12
5
Increases the temperature by 1 °F every 2 hours
to allow a more comforable adjustment for the user.
7 SLEEP
8 °C/°F(CELSIUS AND FAHRENHEIT
EXCHANGE BUTTON)
When the displayed temperature is °C (or °F), you
can press this button to switch to °F (or °C).
1 2 4 3 5
6
Dry
Dry
5
2
1
8 8
1
3
9
4
7
Dry
9 CONTINUOUS
After setting continuous, the unit will keep running
no matter what temperature is selected.
Operation of functions is the same when using the remote
or the control panel, unless otherwise stated.
NOTE:
The remote sensor is located under the LED display.
Point the remote anywhere at the sensor. The remote may
not work if the sensor is in bright light or if there is not a
clear path between the remote and the sensor.
In COOL and DRY modes, the buttons
adjust the set temperature up to 86°F or down to
60°F, in one degree increments. The temperature
can be switched between degrees Fahrenheit and
degrees Celsius, pressing the button and
button at the same time, or pressing °F /°C button
on the remote.
When the TIMER function is selected, use the
buttons to adjust the delay time from 1 to
24 hours, in one hour increments.
If you press and hold the buttons, the set
temperature or time will change automatically after
a few seconds.
NOTE: The displayed temperature is the SET
temperature, not the room temperature. In COOL or
DRY mode, the thermostat in the air conditioner
will run the compressor until the set temperature is
reached, then cycle the compressor on and off to
maintain the set temperature.
/ (TEMP/TIMER)
LED Display 6
LED display shows the set temperature, fan
speed, or the selected TIMER delay.
Indicators will light to show active mode and
additional settings. The LED display will show
the FL to indicate when the internal water drain
tank needs to be emptied.
H O W T O U S E
AUTO RESTART
During operation in failure o
Plug in, the LED display will light
When you plug the power cord into grounded outlet,
LED display will show room tempreature and power indicator(red light)
After push power button to operate the product,
red light above the power button will be changed gree light
f electric power,
the unit runs as previous setting operation.
NOTICE
NOTICE