LG LSRE307ST - Manual (Page 31)

- 31 -
ENGLISH
REMOVING &REPLACING THE
WARMING DRAWER
To Remove Warming Drawer:
1. CAUTION - Always turn off all power to the warming
drawer before attempting to remove it.
2. Open the drawer to the fully opened position.
3. Remove the 2 screws (right and left sides). (refer to the
drowing below)
4. Locate glide lever on each side of drawer, push down on
the left glide lever and pull up on the right glide lever.
5. Pull the Warming Drawer away from the range.
To Replace the Warming Drawer:
1. Replace shield on the right glide of the drawer body.
2. Pull the bearing glides to the front of the chassis glide.
3. Align the glide on each side of the drawer with the glide
slots on the range.
4. Push the drawer into the range until levers click
(approximately 2 inches). Pull the drawer open again to
seat bearing glides into position. If you do not hear the
levers click or the bearing glides do not feel seated,
remove the drawer and repeat steps 2-4.
This will minimize possible damage to the bearing glides.
O V E N V E N T
The oven vent is located above the left rear surface unit.
This area could become hot during oven use.
It is normal for steam to come out of the vent.
The vent is important for proper air circulation. Never block
this vent.
MAINTENANCE
Push down with finger
Lever
Pull up with finger
Lever
Remove screw
WARNING
• Always turn off all power to the warming
drawer before attempting to remove it.
- Failure to do so can result in severe personal
injury,death or electrical shock.