LG LRSC26925TT - Manual (Page 15)

Please select this function for prompt freezer.
”OFF➝ ICE PLUS➝ JET➝ OFF” or
”OFF➝ ON➝ OFF” is repeated
whenever pressing button.
The arrow mark graphic remains at the
On status after flickering 4 times when
selecting Special Refrigeration On
Prompt freezer function automatically
turns off after a fixed time passes.
JET FRZ : Not applicable to all models.
Jet Freezer
• It is normal that a noise is produced when ice drops into the ice storage bin.
NOTE
Ex) In selecting
On
Ex) In selecting
Off
Ex) In selecting
On
JET JET JET
This button stops operation of different
button and dispenser function.
Locking or Release is repeated
whenever the is pressed more than 3
seconds.
If you use the LOCK button, none of the other
buttons will work until you unlock them.
Lock
LOCK
Ex) In selecting
LOCK
Ex) In selecting
UNLOCK
3 SECS LOCK LOCK
DISPENSER & BUTTON DISPENSER & BUTTON
3 SECS
LOCK
15
Operation
Ice is lumped together
If the ice lumps together, take it out, break it apart, and put it back into the storage
bin.
When the ice maker produces too small or lumped together ice, the amount of
water supplied to the ice maker needs to adjusted. Contact the service center.
❈ If ice is not used frequently, it may lump together.
Power failure
Ice may drop into the freezer compartment. Take the ice storage bin out and discard
all the ice then dry it and place it back. After the machine is powered again, crushed
ice will be automatically selected.
The unit is newly installed
It takes about 12 hours for a newly installed refrigerator to make ice.
When ice maker
does not operate
smoothly
The automatic icemaker can automatically make 8 cubes at a time,
120~150 pieces per day. This quantity may vary by circumstance, including ambient
temperature, door opening, freezer load. etc.
Icemaking stops when the ice storage bin is full.
If you don't want to use automatic icemaker, turn the icemaker switch to OFF. If you
want to use automatic ice-maker again, change the switch to ON. To switch ON/OFF
Automatic
Icemaker
1
2
follow steps 1 & 2 in the picture.
ON OFF