LG WM2550HWCA - Manual (Page 34)

TROUBLESHOOTING/SPECIFICATIONS/OPTIONAL ACCESSORIES
Steam Washer™ Model WM2550H*CA
Description Front-Loading Washer
Electrical Requirements 120 VAC @ 60 Hz.
Max. Water Pressure 14.5~116 PSI (100~800 kPa)
Net Weight 192 lbs. (87 kg)
Max. Spin Speed 1,200 RPM
Dimensions 27”(W) X 29 3 /
4
”(D) X 38 11 /
16
”(H), 51”(D with door open)
68.6 cm (W) X 75.6 cm (D) X 98.3 cm (H), 129.7 cm (D with door open)
OPTIONAL ACCESSORIES
For these and other LG products, contact your local LG dealer, or visit our Web site at www.lg.com.
Pedestal
Give your LG washer and dryer a boost with matching
14-inch high pedestals. They feature a storage drawer
for added convenience.
14” Pedestal
Color
WDP4C Chardonnay Steel
WDP4R Wild Cherry Red
WDP4V Graphite Steel
WDP4W White
Stacking kit
If space is at a premium, use this kit to securely
stack your LG front-load washer and dryer.
Bracket Kit Color
CSTK1 Chardonnay
RSTK1 Wild Cherry Red
SSTK1 Titanium
WSTK1 Whtie
kEY DIMENSIONS AND SPECIFICATIONS
The appearance and specifications listed in this manual may vary due to constant product improvements.
USING SMARTDIAGNOSIS™
- Only use this feature when instructed to do so by the call center. The transmission sounds similar to a fax machine, and so has no meaning except to the call center.
- SmartDiagnosis™ cannot be activated if the washer does not power up. If this happens, then troubleshooting must be done witho ut SmartDiagnosis TM .
If you experience problems with your washer, call 1-800-243-0000 (1-888-542-2623 in Canada). Follow the call center agent’s instructions, and do the
following steps when requested:
Press the POWER button to turn on the washer. Do not press any other buttons or turn the cycle selector knob. 1
When instructed to do so by the call center, place the mouthpiece of your phone very close to the POWER button. 2
Press and hold the WASH/TEMP. button for three seconds, while holding the phone mouthpiece to the icon or POWER button. 3
Keep the phone in place until the tone transmission has finished. This takes about 15 seconds, and the display will count down the time.
• For best results, do not move the phone while the tones are being transmitted.
• If the call center agent is not able to get an accurate recording of the data, you may be asked to try again.
• Pressing the POWER button during the transmission will shut off the SmartDiagnosis™.
4
Once the countdown is over and the tones have stopped, resume your conversation with the call center agent, who will then be able to assist you using the
information transmitted for analysis at the call center.
5
34
MFL62526880_en_110329.indd 34 3/29/11 2:01:32 PM