LG LHB975 - Manual (Page 20)

20 Installation
Installation
3
LED indicator of wireless receiver
LED Color Operation
Blue The wireless receiver is
receiving the signal of the
wireless transmitter.
Red The Wireless Receiver is in
standby mode.
Off (No
display) The Wireless Receiver is
turned off .
Initial setting an ID of wireless
receiver
1. Connect the Wireless Receiver and the rear
speaker (right, left) with the speaker cables.
2. Connect the power cord of the Wireless
Receiver to the outlet.
3. Turn on the main unit and Wireless
Receiver: The main unit and wireless
receiver will be automatically connected.
“z” appears in display window.
Setting an ID of wireless receiver
When the unit is manufactured, the ID is
already set. If an interference occurs or you use
a new wireless receiver, an ID should be set
again.
1. Turn on the main unit and turn off the
wireless receiver.
2. Press and hold x (STOP) on the front of unit
and MUTE on the remote control. “REMATE”
appears in display window.
3. Turn on the Wireless Receiver. A new ID is
set.
NOTE
• If there is a strong electromagnetic wave
product nearby, interference may occur. Put the
unit (Wireless Receiver and main unit) away from
there.
• If there is no audio signal for longer than 10
minutes, the Wireless Receiver will automatically
switch to standby mode. In power saving mode,
both LEDs will turn red. LEDs will turn blue when
there is any audio signal back.
• If you operate main unit then wireless speakers
(rear speakers) sound within a few seconds in
standby mode.
• Set the distance between this unit and Wireless
Receiver within 10 m (32 ft.).
• Optimum performance can be implemented
only when the Wireless Transmitter and the
Wireless Receiver within distance of 2 m (6 ft.) to
10 m (32 ft.) is used since communication failure
may occur if longer distance is used.
• Be sure to match the speaker cable to the
appropriate terminal on the components: + to +
and – to –. If the cables are reversed, the sound
will be distorted and will lack bass.
• It takes a few seconds (and may take longer) for
the Wireless Transmitter and Wireless Receiver to
communicate with each other.
• Use the rear speaker at least 30 cm (11 inch)
away from either TV screen or PC monitor.
HB965PZT-AD.BUSALL_ENG_6864.indd 20 HB965PZT-AD.BUSALL_ENG_6864.indd 20 10. 10. 20 9:16 10. 10. 20 9:16