LG WG1205R - Manual (Page 18)

Operating Instructions
The controls look like th
is:
Control
Remote Control Operations
REMOCON SIGNAL RECEIVER
ENERGY SAVER
The fan stops when the compressor stops cooling.
Approximately every 3 minutes the fan will turn on and check the room air to determine if cooling is needed.
FAN SPEED
Pressing the Fan speed button toggles between Low ,Mid and High speeds.
MODE
Everytime you push this button, it will toggle between COOL, FAN, and DRY.
ON/OFF TIMER
Each press of the button cycles through the options in this order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours C ANCLE
The set t emperature will be raised by 2 F after 30 minutes and again after another 30 minutes.
POWER
To turn the air conditioner ON, push the button. To turn the air conditioner OFF, push the button again.
This button takes priority over any other buttons.
When the unit is first powered up, it defaults to settings of High Cool at 72 F
TEMPERATURE SETTING
This button can automatically control the temperature of the room. The temperature can be set within a range
of 60 F to 86 F by 1 F.(16 C to 30 C by 1 C)
Select the lower number for lower temperature of the room.
Each press of the button cycles through the options in this order:
1Hour 2Hours 3Hours 4Hours 5Hours 6Hours
7Hours 8Hours 9Hours 10Hours 11Hours 12Hours C ANCEL
- Stopping Operation
- Starting Operation
１
２
３
４
５
６
７
18 Room Air Conditioner