Audiovox Prestige Platinum 128-4634D - Manual

Page 1
SELECTABLE FEATURES
Note : The method of manual override can either be selected to operate from the valet switch or operate as custom code. Be
certain to place a check mark indicating the method used in the box located on the last page of the owner's manual.
Wire Loop Selectable Features :
Wire Color Closed Loop Cut Loop
Gray Loop Custom Code Manual Override Valet Switch Manual Override
Green Loop Voltage Sense Hardwire
Note : When both Passive Arming and Voltage Sensing are selected, you must hardwire the driver’s door pin switch in order
to begin the passive arming sequence.
RF Programmable Features :
Feature Selection 1 Chirp 2 Chirps Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second Auto Lock On Auto Lock Off Auto Lock Off
Third Auto Unlock On Auto Unlock Off Auto Unlock Off
Fourth No Function No Function —————————-
Fifth Passive Door Locks Active Door Locks Passive Locks
Sixth Passive Arming Active Arming Active Arming
To program these selectable features;
Action System Response
Turn ignition on No response
Flip valet switch on then off 3 times 1 Chirp - LED 1 flash
Within 3 seconds, turn ignition Off Short chirp, then long chirp
First Then On 1 chirp = 1 second door locks
Press transmitter button 1 to change 2 chirps = 3.5 second door locks
o r
Second Flip valet switch on then off 2 chirps = auto locks off
Press tranmitter button 1 to change 1 chirp = auto locks on
o r
Third Flip valet switch on then off 2 chirps = auto unlock off
Press transmitter button 1 to change 1 chirp = auto unlock on
o r
Fourth Flip valet switch on then off 1 chirp = No Function
Press transmitter button 1 to change 2 chirps = No Function
o r
Fifth Flip valet switch on then off 1 chirp = passive locks
Press transmitter button 1 to change 2 chirps = active locks
o r
Sixth Flip valet switch on then off 1 chirp = passive arming
Press transmitter button 1 to change 2 chirps = active arming
o r
Flip valet switch on then off Exit program mode
o r
Turn ignition key off Exit program mode
Note : Once you enter the feature programming mode, do not allow more than 15 seconds to pass between steps, or the
programming will be terminated.
Model APS 400
Installation Manual