Arboria Hampton Landscape Screen none User Manual
Page 2
2
Division of LWO Corporation
3841 N. Columbia Blvd.
Portland, Oregon 97217
(503) 286-5372 (800) 459-8718
www.arboria.com
INSTALLATION
Screens are equipped with (2) 36” Steel Stakes for in-ground, freestanding
installation. These can be mounted to either the side or back of the Base
Panel.
Placement of Stakes
If mounting the Stakes on the back of the Base Panel, drive the first stake
14” to 18” into the ground in the desired location. Be sure to position the
stake such that the top edge of the “U” shaped stake faces the Panel.
Measure 34” apart from this first stake and then drive your second stake
14” to 18” into the ground.
If mounting the Stakes on the side of the Base Panel, drive the first stake
14” to 18” into the ground in the desired location. Measure 36.5” apart
from this first stake, between which your Base Panel will be installed, and
then drive your second stake 14” to 18” into the ground.
Attaching Panel to Stakes
We recommend installing the screen so that the bottom of the posts are
1” above the ground.
Use the 1 5/8” wood screws to secure the screen to the stakes. Screw
through the holes in the stake into the Panel frame and be sure to use the
highest and lowest possible holes on each post.