LG LS42F - Manual (Page 70)

24 GB
FWD-S42H1/FWD-S47H1
4-111-559-01(1)
For PC Input
When input is switched to a PC input source, the
“Picture/Sound” settings specific to PC input are
applied.
The “Picture/Sound” settings for a PC include the
following options:
Picture Mode “Vivid”: Select for enhanced picture contrast and sharpness.
“Standard”: Select for standard picture settings.
“Custom”: Allows you to store preferred settings.
“Conference”: Adjusts the picture quality for video conferencing under fluorescent
lights.
“TC Control”: The setting is common with “Vivid”. In addition, you can use the
“True Color Control” function (after-mentioned).
Tip
To change from one “Picture Mode” option to another, you can also use PICTURE on the
remote control instead.
• “Conference” may not be effective depending on the environment or the video conference
system under use. In this case, adjust the picture quality, switch to other settings of “Picture
Mode”, etc.
• In “TC Control”, “Brightness Boost” is fixed to Off.
Picture Mode Adjust. “Backlight”: Adjusts to brighten or darken the screen.
“Contrast”: Adjusts picture contrast.
“Brightness”: Adjusts to brighten or darken the picture.
“Gamma Correct.”: Balances the light and dark portions of pictures. Select from
“High”, “Mid”, “Low” to make settings.
• “Option”can only be set when there is a DVI input.
• Gamma setting is in accordance with the Grayscale Standard Display Function (GSDF) of
the Digital Imaging and Communications in Medicine (DICOM) standards. However, this
setting is for reference only and cannot be used for medical diagnosis.
“Color Temp.”: White tone can be adjusted to suit your preference. The factory
default settings are adjusted to color temperature.
“Cool”: Select to give the white colors a blue tint.
“Neutral”: Select to give the white colors a neutral tint.
“Warm”: Select to give the white colors a red tint.
“Custom”: Enables a broader range of white tone to be set than above.
Tip
Restores the default settings by selecting “Reset” on the tone adjusting screen.
“Brightness Boost”: Emphasizes the brightness of the image.
• When “Brightness Boost” is set to “On”, you cannot adjust the “Backlight”, “Contrast”,
“Brightness” or “Color Temp.” settings.
• When “Brightness Boost” is set to “On” and “ECO Mode” is switched “Off”, the brightness
is at its maximum.
“True Color Control”: You can adjust the details of hue and saturation for each of
4 colors : red, green, yellow, blue, and you can highlight specific colors in the image.
Select the color which you want to adjust, and you can check and see which part of
current image will be adjusted. Then you can adjust it using the matrix dialog.
Notes
Notes
Notes
010COV.book Page 24 Friday, June 27, 2008 7:25 AM