Ayre Acoustics V-6xe - Manual (Page 9)

In the green “Standby” mode the output stage is
turned off, while the input circuitry remains
powered. This allows the unit to warm up quickly
for optimal sonic performance, while reducing the
power consumption from 60 watts per installed
channel to 20 watts.
Trigger Input
Use a 1/8" mini-phone plug
with a positive voltage of
between +5 and +12 VDC
at the tip to operate the trigger
input.
A trigger input is provided on the rear panel of the
V-6xe to allow for remote switching between the
green “Standby” and blue “Operate” modes. The
two trigger input jacks are wired in parallel. Either
jack can act as an input or a pass-through output to
allow for “daisy-chaining” of multiple devices.
The unit is shipped from the factory in the
level-sensitive mode, which is compatible with most
equipment. During level-sensitive operation,
applying a voltage to the trigger input will force the
amplifier to the “Operate” mode. In this state, the
front panel switch is inoperative. When the applied
voltage drops to zero, the unit reverts to “Standby”
and the front panel switch may be used to manually
control the unit.
Some equipment instead utilizes pulses as a trigger
signal. The V-6xe can also accommodate these units.
To change trigger modes, turn the rear panel switch
“Off” for about 30 seconds to discharge the internal
voltages. Then press and hold the front panel switch
while turning the rear panel switch “On”. The status
LED will rapidly flash red (about 10 Hz) to indicate
that the pulse-sensitive mode has been selected.
7