LG V-C3245ND - Manual (Page 21)

– 20 –
E
Connecting the flexible hose
Push the end of the head
(1)
on the flexible
hose
(2)
into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the
vacuum cleaner, press on the button
(3)
situ-
ated on the head, then pull upwards.
Assembling the tubes
(depending on model)
•
Metal tube(4)
- Fit together the two tubes by twisting
slightly.
•
Telescopic tube(5)
- Push spring latch
(6)
forward.
- Pull out tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Nozzles
(depending on model)
Fit the large cleaning head onto the end of
the tube.
•
The 2 position head(7)
is equipped with a
pedal or two pedals
(8)
which allows you to
alter its position according to the type of
floor to be cleaned.
Hard floor position
(tiles, parquet
floors...). Press on the pedal to lower the
brush.
Carpet or rug position.
Press on the
pedal to lift the brush up.
•
Crevice Tool(9)
For vacuuming in those normally inaccess-
ible places i.e. reaching cobwebs, or down
the side of a sofa!
•
Dusting brush(10)
For vacuuming picture frames furniture
outlines, books and other uneven objects.
•
Upholstery Nozzle(11)
For vacuuming uphostery, mattresses, etc.
The thread collectors help to pick up the
threads and fluff.
How to plug in and use
Pull out the supply cord to the desired
length and plug into the socket.
Press button
(13)
to start the vacuum cleaner.
To stop it press the button
(13)
again.
Adjusting the power level
• If your appliance is equipped with an elec-
tronic variable power control
(13),
you can
choose the power appropriated for the
task. (depending on model)
• The flexible hose handle
(14)
has a manual
air flow regulator
(15)
which allows you to
briefly reduce the suction level.
Storage(16)
When you have switched off and unplugged
the appliance, press on the button
(12)
to
automatically rewind the cord.
You can move or store your appliance in a
vertical position by sliding the hook on the
large cleaning head into the clip on the
underside of the appliance.
How to Use
Changing the dust bag
The dustbag needs changing when the cleaner
is set to maximum power and the cleaner head
is off the floor but the “bag full” indicator win-
dow
(17)
is completely coloured red.
Even if the dustbag does not appear to be
full at this stage, it should be changed.
It could be that a great deal of very fine dust
has clogged up the pores of the dust bag.
• Turn off the appliance and unplug it.
• Open the cover by pressing the hook
(18)
and lifting it up until it snaps into place.
Your appliance is equipped with either a
paper dust bag
(19)
or a fabric dust bag
(21)
(depending on model).
• Take hold of the dust bag by the handle
and pull.Remove the bag and throw it
away.
• To refit a new bag push the cardboard
support of a new bag into the bag mount
(20)
until it will go no furthe r.
If your appliance is fitted with a fab-
ric dust bag
follow the same instructions
as above.
Empty it and replace it
(21)
.
Note
: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not fit-
ted correctly.