Setting the clock – Aiwa NSX-AJ20 User Manual
Page 7
En
ENGLISH
7
SETTING THE CLOCK
1 Press CLOCK while pressing SHIFT on the remote
control.
When using the unit, press
a
a
a
a
a
while the power is off.
The clock is displayed. (The “:” between the hours and minutes
flashes.)
2 Within 4 seconds, turn MULTI JOG to designate
the hour and the minute.
Turning MULTI JOG changes both the hour and the minute.
f
or
g
is also available in place of MULTI JOG. Holding
these buttons down will vary the time rapidly.
3 Press ENTER or
a
.
The clock starts from 00 seconds.
To restore an original clock setting
Press CLOCK while pressing SHIFT on the remote control before
completing step 3 to restore the previous time setting. This
cancels any new setting.
To view the clock when another display is in the display
Press CLOCK while pressing SHIFT on the remote control. The
time is displayed for 4 seconds and then the original display
reappears. However, the clock cannot be displayed during
recording.
To switch to the 24-hour standard
Press CLOCK while pressing SHIFT on the remote control and
then press
s
within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, “AM 12:00” indicates midnight and
“PM12:00” indicates noon.
If the clock display flashes
If the display flashes when the clock is displayed, it indicates
that the clock has stopped due to a power failure or the removal
of the power cord. The current time needs to be reset.
If the power-economizing mode (page 6) is on, the unit blacks
out when the power is turned off. To view the clock, press CLOCK
while pressing SHIFT on the remote control so that the time is
displayed for 4 seconds.
PREPARATIONS