American DJ XDM-241 User Manual
Page 2
© American DJ® AUDIO Los Angeles, CA 90058 USA
Specifications subject to change without notice. XDM-241 User Instructions page 2
Operating Determinations
When installing this mixer, please make sure that the device is not exposed to extreme heat, moisture or dust! There
should not be any cables lying around. Doing so endangers you as well as others.
Do not operate the mixer in extremely hot (more than 30˚C / 100˚F) or extremely cold (less than 5˚C / 40˚F) surround-
ings. Keep away from direct sunlight and heaters.
Operate the mixer only after becoming familiar with its functions. Do not permit operation by persons not qualified for
operating the mixer. Most damages are the result of unprofessional operation!
Never use spray cleaners to clean the faders!
Never use solvents or abrasive detergents to clean the mixer! It is recommended that you use a soft damp cloth.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
Connections (Refer to diagrams on pages 3 & 4)
• Make sure that the power switch (1) is set to OFF. Before connecting other devices to the mixer, all units have to be
switched off and the Master Control (11) set to min.
• Make sure that the available voltage is the correct voltage (10 Volts) before connecting to power.
• In order to obtain the highest sound quality, use high quality American DJ
®
Ameri-Cable™ cables for connecting
devices. Make sure that the cables are properly fixed.
• Connect your amplifier to the OUT AMP jacks (16).
• For recording, connect your tape recorder or cassette deck to the OUTPUT REC jacks (15). The REC OUT level will
not be influenced by the Master Control (11).
• Connect your microphone to the Microphone Input (10). (See diagram)
• Connect your turntable(s) to the PHONO 1 jacks (13) or the PHONO 2 jacks (14) on the rear panel. You can only con-
trol the record player signal after switching the PHONO/LINE switches (2) to phono. The signal is then controlled via the
CH-1 and CH-2 faders (3).
• Connect your tape recorder, tuner, sound effects, CD player, cassette deck or any other line signals to the
PHONO/LINE jacks (13 & 14) on the rear panel. You can only control the line signals after switching the PHONO/LINE
switches (2) to LINE. The signal is then controlled via the CH-1 and CH-2 faders (3).