AMX MAX-AVP - Manual (Page 19)

Installation
13 MAX-AVP Audio-Video Player
8. Put the chassis sections back together and secure the two sections with the four screws removed
earlier.
9. Remove the "feet" from the bottom of the unit. Each foot is secured to the chassis with a single
screw. Keep the feet and screws for further use.
Once the rack-ears have been installed, the AVP can be mounted into the equipment rack.
HDMI-to-DVI Conversion Cable (MDL200 Kit)
The MAX MDL200 Multi Disc Loader System comes as a kit that includes a PowerFile Multi-Disc
Loader, a Windows® PC pre-loaded with all required software, pre-configured for plug and play
operation, equipped with a LCD monitor, keyboard and mouse.
The HDMI-to-DVI conversion cable allows you to connect the LCD monitor that comes with the
MDL200 kit directly to a MAX-AVP Audio-Video Player, to access the AVP’s Setup Pages.
Options in the AVP’s Setup pages allow you to complete initial configurations on the AVP, including:
Audio and video output settings
Fine tuning options (such as brightness, contrast and saturation)
Localization settings (including Region Code settings)
You do not need the conversion cable to use the MDL200, it is included with the kit so that you can use
the LCD monitor to configure a MAX-AVP. Note that the MAX-AVP is not part of the MAX-MDL200
kit.
To connect the LCD monitor to a MAX-AVP, use the conversion cable to connect the HDMI
output on the AVP to the DVI input on the LCD monitor.
To access the AVP’s setup pages, press the SETUP button on the AVP remote.
FIG. 7 Secure the rack-ears to the inside of the chassis
Secure the rack-ears to
the inside of the chassis
front
Refer to the MAX MDL200 Multi Disc Loader System Installation Guide and
Operation/Reference Guide (available online at www.amx.com) for detailed
instructions on using the MDL200 kit to bulk-load media to a MAX Server.
Refer to the Setup Page section on page 46 for details on configuring the MAX-AVP.