HP Impresora HP Designjet serie L65500 - Manual (Page 2)

Note: It is normal that the printer moves approximately 50cm (20”) before the calibration pattern is printed, this is so that
the substrate can reach a stable phase.
Two patterns are printed on the left and right of the loaded substrate, shown above and below is an example: The
patterns are labeled ‘A’ and ‘B’.
At the area where both the magenta and black lines are aligned (indicated above) there is a number, enter this number
into the screen on the Internal Print Server. In the example shown above you would enter +14 as the number where the
two lines are aligned on the A pattern..
After entering both numbers (A and B), select ‘Save’ to apply the calibration and select ‘Done’ to close the window. The
calibration will be used in the next job printed.
The issue of Color Misregistration is mostly caused by contraction or expansion of the substrate, this is due to the amount
of heat applied to it. The Dynamic Color Registration calibration must be performed for each substrate that shows signs of
color mis-registration. If the drying temperature is modified at a later time for any reason, perform the calibration again.
This issue does not occur in every substrate. Substrates that do not show different misregistration problems on each side
of the roll should not be calibrated. If you see a consistent misregistration along the roll width, use Printhead Alignment
instead.
Substrate expansion/contraction does not occur immediately at the beginning of a plot. The printer requires approximately
0.5m of printed substrate before the issue can be seen. After calibrating the printer, it is possible to see an
overcompensation of the first 0.5m of each job, depending on the substrate.
Note: The printer compensates up to 1.2mm of mis-registration on each side of the substrate (up to 2.5 mm in total).
Dynamic Fine Tuning the Calibration while printing
It is possible to calibrate the color mis-registration without actually printing the pattern. Note: Even after calibrating the
printer, the problem may not be completely solved.
In such cases it is possible to enter values in ‘A’ and ‘B’ to directly affect the calibration in a controlled manner. In the
following graphic the letter A represents a graphic or lines that are suffering the issue of color misregistration. In order to
fix the graphic, the magenta lines need to be shifted to the right and to the left.
To change the values while the printer is printing, select ‘Print Adjustments’ menu shown here:
Change the A and/or B values and
click on ‘Apply’.
How to change the A value
Changing the ‘A’ value shifts the position of the Magenta lines on the right edge of the substrate:
Decreasing the value of ‘A’ shift the Magenta lines of the letter A on the right, to the right edge of the substrate.
2