Troubleshooting – Ariens Sno-Thro 921012 User Manual

Page 38

Advertising
background image

GB - 38

TROUBLESHOOTING

PROBLEM

PROBABLE CAUSE

CORRECTION

Engine will not
crank/start.

1. Fuel tank is empty.
2. Fuel shut-off valve closed.
3. Build up of dirt and residue

around
governor/carburetor.

4. Key Switch not in run

position.

5. Electric starter not

functioning.

1. Fill fuel tank.
2. Open fuel shut-off valve.
3. Clean area around

governor/carburetor.

4. Put Key Switch into run position.

5. Check for a bad starter or

connections.

Engine stops.

1. Out of fuel.
2. Fuel shut-off valve closed.
3. Mechanical jam in blower

rake or impeller.

4. Polluted fuel supply.
5. Faulty spark plug.

1. Fill fuel tank.
2. Open fuel shut-off valve.
3. Turn off engine, remove key, and

wait for all moving parts to stop.
Check for and remove
obstruction and repair before
restart.

4. Replace with clean fuel.
5. Replace or clean spark plug.

Engine
problems.

1. See Engine Manual.

1. See Engine Manual.

Does not
operate in
Forward /
Reverse.

1. Friction disc not adjusted

properly.

2. Traction belt not

functioning.

3. Speed selector not

adjusted properly.

1. Repair or replace friction disc.

See Friction Disc Replacement
on page 35.

2. Repair or replace traction drive

belt. See Friction Disc
Replacement
on page 35.

3. Adjust speed selector. See

Speed Selector Adjustment on
page 29.

Small rubber
beads collect
in frame

1. Friction disc wear.

1. Normal friction disc wear. Chunks

or large pieces of rubber mean
friction disc should be checked
and replaced as necessary.

Unit throws
snow poorly or
does not throw
snow.

1. Shear bolts broken.

2. Attachment clutch/brake

not adjusted properly.

3. Auger is frozen in place.

4. Ice or debris is obstructing

auger.

5. Attachment drive belts

slipping, worn or damaged.

1. Replace shear bolts (see Shear

Bolts on page 27).

2. Adjust attachment clutch/brake

(see Attachment Clutch/Brake
Adjustment
on page 30).

3. Move unit to a warm place to

thaw.

4. With the engine off and auger

disengaged, check for
obstructions and remove.

5. Adjust or replace attachment

drive belts (see Attachment Drive
Belt Replacement
on page 33).

Advertising