HP LD4730 47-inch Micro-Bezel Video Wall Display - Manual (Page 50)

Level 1 Menu Level 2 Menu Level 3 Menu Description
ISM Method To prevent the screen from retaining an image that remains
static for a long period of time, choose one of these relief
methods:
● Orbiter— The image moves two pixels every two
minutes. Direction of movement is right, left, up, and then
down, in a continuous cycle.
● Inversion — Inverts the colors every 30 minutes. This
function can be used to fix a ghost or burned-in image.
● White wash — Fills the screen with white. This function
can be used to fix a ghost or burned-in image. Press any
key on the remote control to exit the White Wash function
and return the screen to normal.
● Dot wash — Imposes black dots on the image, moving
them every 5 seconds.
● OFF — No remedy for image retention will be used.
The default setting is Off.
DDC/CI On — Allows an attached media player/computer to send
control commands to the display.
Off — Control of the display must be done manually, with the
infrared remote control or the buttons on the back of the
display.
The default setting is On.
Factory Reset Resets all OSD choices to their default factory settings.
User modes will be erased from memory.
Diagnostic Shows the following information:
Temperature in degrees Centigrade
Ambient light level in Lux
LED Failure: Yes/No
Operating time in hours
Information Shows the following:
Serial number
SW Version (MNT) — The version of the firmware driver
running on the display.
IP Address (VOE) — The IP Address of the network
connection handling video data to the display.
MAC Address (VOE) — The Media Access Control address
of the network connection handling video data to the display.
IP Address (NSM) — The IP Address of the network
connection handling control data to the display.
MAC Address (NSM) — The Media Access Control address
of the network connection handling control data to the display.
42 Chapter 4 Operating the display ENWW