Autostart AS-2500 TW User Manual
Page 4
Alarm Clock
The LCD Remote Control has a built-in Alarm Clock which can be set up
using the
button. Use the
and
buttons to switch the Alarm Clock
on and off (refer to the tables).
Time Adjust Mode
Use Time Adjust Mode to set the current time on your Remote Control
using the
button (refer to the tables).
Countdown Timer
This feature allows set up a countdown of a duration entered by the user in
hours and minutes using the
button (refer to the tables).
Parking Countdown
This version of the Countdown feature is particularly useful for keeping
track of parking meter time: the user may quickly set up the countdown in
slices of 10 or 30 minutes using the
and
buttons (refer to the tables).
Melody Selection
The Remote Control allows the user to select which melodies are to be
used upon the following events: remote starting of the vehicle, the Alarm,
ending of the countdown, entering Cold Weather Mode. Melodies for these
various events can be selected using the
button (refer to the tables).
Vibration Mode
Use this feature to replace audible signals with a vibration signal. Use
the
and
buttons to switch Vibration Mode ON and OFF (refer to the
tables).
Power Saving Mode
When set to Power Saving Mode, the Remote Control will cease polling the
Remote Starter Module on a regular basis for status information. This will
extend battery life. Use the
and buttons to switch Power Saving
Mode ON and OFF (refer to the tables).
Remote Control Finder
This function allows the user to locate the Remote Control when it has been
accidentally dropped near the vehicle. Pressing the Valet Button and
holding it down for 3 seconds (or until the Parking Lights flash five times)
will cause the Remote Control to start beeping for one minute. The beeping
P. 4 User
Guide
AS-2500 TW