HP df1010p1 Rahmen für Digitalbilder - Manual (Page 6)

6
Remote Control
You can access all of the DPF’s features, and perform all of the functions by using the remote control. You will be able to
perform several functions with the remote control that are not possible with the top-back panel control buttons.
Note: Before first time use, pull the plastic tab sticking out of the remote control. It protects the battery and the remote
control will not work unless it is removed.
1 Start Slideshow
2 Exit or go back 8 Access Setup screens (Menu)
3 Scroll up
4 Scroll previous 9 Scroll forward
5 Play/Pause/Select object 10 Scroll down
6 Volume adjust higher 11 Rotate image
or Select object
7 Volume adjust lower 12 Enlarge image
or De-select object
Replace the Remote Control Battery
1. Hold the remote control with the buttons facing down.
2. Push and hold the small release tab while pulling the battery tray out.
3. Replace the “CR2025” Lithium battery on the tray with the positive (+) side facing up.
4. Push the tray back in until it clicks into place.
Control Buttons on DPF
You can perform many (but not all) of the DPF functions by using the control buttons located on the top-back panel of the
DPF. Their basic functions are the same no matter when you use them.
TIP: The instructions throughout this User Guide only reference the use of the remote control. However, if desired, you
can use the frame control buttons when these buttons are referenced:
Remote Frame Action
 Scroll left
ENTER Play/Pause/Select object
 Scroll right
EXIT Exit the current display, or go back a screen
MENU Access Setup screens
Release tab
2
3
4
5
7 12
9
10
6 11
1
8