HP 3PAR Recovery Manager Software for VMware vSphere Licenses - Manual (Page 103)

Table 7 Recovery Manager for Microsoft Exchange Event Messages (continued)
Description/Action Error Message Event ID
The storage group is spread across multiple HP
3PAR Storage Systems.
•
The database or log target volume must belong
to a single HP 3PAR Storage System. Refer to
the preferred configuration setup.
RME3112: ERROR: Your database is spread
across multiple InServs on the production
server. Please move the storage group to
only one InServ and perform this operation
again. 3112
Failed to save the information to the configuration
file.
•
Check that you have right permissions to the
RMExchange Repository
directory.
RME3122: ERROR: Unable to configure peer
backup server. 3122
Failed to save the information to the configuration
file.
•
Check that you have correct permissions to the
RMExchange Repository
directory.
RME3126: ERROR: Could not delete the
local configuration file. 3126
The Exchange server cannot determine the specific
storage groups to set up because the current range
is to wide.
•
Unregister all storage groups and then register
only the desired groups one by one.
RME3137: ERROR: The Exchange server is
set to include all storage groups. Please
remove this umbrella to register individual
Storage Groups. 3137
The specified zip file already exists.
• Change the zip file name or delete the existing
zip file.
RME3150: ERROR: The zip file already
exists. 3150
An invalid file name format was specified for the
zip file.
•
Check the syntax for the zip file name specified
by the RMExch report command.
RME3151: ERROR: The filename must end
with .zip. 3151
The storage group name is missing from the RMExch
command syntax.
• The storage group name must be included in the
CLI command parameters.
RME3155: ERROR: Missing storage group
name. 3155
The number of virtual copies is out of the range
specified by the current policy.
•
Reduce the number of virtual copies for this
procedure or modify the policy by raising the
maximum number of virtual copies allowed.
RME3157: ERROR: Number of virtual copies
need to be in the range of 1 to <Max.
Count>. 3157
An invalid parameter was specified for the RMExch
policy
command. Check the syntax for the
RME3158: ERROR: Invalid parameter
entered for policy command. 3158
RMExch policy command for the correct
parameters.
103