HP StorageWorks 2.32 Edge Switch - Manual (Page 242)

Informational and error messages 242
Cannot run diagnostics
while a device is
logged-in to the port.
Port diagnostics (internal
loopback test) cannot be
performed on a port
while an attached Fibre
Channel device is logged
in.
Ensure the device is logged out
and perform diagnostics again.
Cannot run diagnostics
while a device is
logged-in to the port.
A device is logged in to
the port where a
diagnostic test is
attempted.
Log out the device and run the
diagnostic test again.
Cannot save IPL
configuration while
active=saved is enabled.
You cannot save the IPL
file while the
active=saved property is
set.
The FICON Management Server
property, active=save, must be
disabled for HAFM to save the IPL
file.
Cannot save port
configuration.
The port configuration
cannot be saved at the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot save SNMP
configuration.
The SNMP configuration
cannot be saved at the
Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot set all ports to 1
Gb/sec due to speed
restriction on some ports.
Displays if you try to set
ports to operate at 1
Gb/sec data speed
through the Configure
Ports dialog box and
some ports do not support
speed configuration.
Replace ports that do not support
speed configuration with those that
do support more than one
configuration.
Cannot set all ports to 2
Gb/sec due to speed
restriction on some ports.
Displays if you try to set
ports to operate at 2
Gb/sec data speed
through the Configure
Ports dialog box and
some ports do not support
speed configuration.
Replace ports that do not support
speed configuration with those that
do support more than one
configuration.
Table 30 Element Manager messages (continued)
Message Description Action