HP NonStop G-Series - Manual (Page 124)

NonStop AutoTMF Software Commands
HP NonStop AutoTMF Software User’s Guide—429952-014
6-50
COPY
This option applies to key sequenced files only.
TRIM trim-character
delete any trailing character matching the trim-character. The character is
specified in ASCII using quotation marks or as an integer in the range 0 to 255.
UNLOADIN | NO UNLOADIN (magnetic tapes only)
input tape is unloaded (or not unloaded) after the tape has been rewound. The
default is UNLOADIN. This also applies to labeled tapes.
UNSTRUCTURED
open and access the input file using the unstructured option. This option can
be used for Enscribe unstructured or structured files where the file structure is
ignored.
VARIN
read variable length blocked records. These records can be produced by using
the VAROUT COPY command option described below. Each record is
preceded by a one word indicator that contains the record length in bytes.
out-options
BLOCKOUT n
number of bytes from 1 to 32767 in an output record. When BLOCKOUT is not
specified, the RECOUT value is used. The default is device dependent: 80
bytes for terminal, 132 bytes for a process and unstructured files. If
BLOCKOUT is greater than RECOUT, the output block is filled with RECOUT-
value length records until the block contains BLOCKOUT-value bytes or the
last output record is encountered.
EBCDICOUT
translate output characters from ASCII to EBCDIC.
FOLD
output records longer than the output record length will be divided into as many
output records as needed to copy the entire record.
PAD pad-character
output records shorter than the output record length will be padded with pad-
character. Specify pad-character as an ASCII character in quotation marks or
as an integer in the range of 0 to 255.
RECOUT n
maximum length between 1 and 4096 of an output record.
REWINDOUT | NO REWINDOUT (magnetic tapes only)