HP NonStop G-Series - Manual (Page 88)

Triggers
HP AutoSYNC User’s Guide—522580-019
6-8
Note on Triggers that invoke SQLCI
Instead, the user should use the following command:
where the TRIGTACL macro is as follows:
The TACL macro invoked by the TRIGGER must reside on the destination system and
must utilize an INLINE SQLCI. Multiple AutoSYNC built-in arguments (#SYNCFILE,
#SOURCEFILE, so on) may be passed to the macro but code must be added to
retrieve the values.
SYNC $data.test.sqacct TO \paris.$datab.testb.sqacctb,
TRIGGER "RUN TRIGTACL #SYNCFILE";
?tacl macro
#frame
========================================================
== setup
==
#push sqlci_out
#set #inlineecho 1 [#push #inlineecho]
#set #inlineprefix // [#push #inlineprefix]
========================================================
== pick up the tacl parameter(s) from the trigger command
==
#set SYNCFILE %1% [#push SYNCFILE]
========================================================
== sample sqlci command and forcing display for the logfile
==
sqlci /inline , outv sqlci_out/
// secure [SYNCFILE] PROGID;
// exit;
#outputv sqlci_out == forces display for recording in logfile
#unframe