HP Storage Mirroring Software - Manual (Page 128)

Job monitoring Page 127 of 214
4044 An error was encountered and replication has been stopped. It is necessary
to stop and restart the service to correct this error.
Error—Contact technical support if this error persists.
4045 %1 value must be between 1025 and 65535. Using default of %2.
Error—Verify that the Storage Mirroring port value you are trying to use is
within the valid range. If it is not, it will automatically be reset to the default
value.
4046 This service failed to start because of a possible port conflict. Win32 error:
%1
Error—Verify that the Storage Mirroring ports are not conflicting with ports
used by other applications.
4047 Could not load ZLIB DLL %1. Some levels of compression will not be
available.
Error—The compression levels available depend on your operating
system. You can reinstall the software, using the installation Repair
option, to install a new copy of the DynaZip.dll, or contact technical
support if this error persists.
4048 Service has started a delete orphans task to %1 (%2) for Replication Set %3,
ID: %4
Information—No action required.
4049 Service has paused a delete orphans task to %1 (%2) for Replication Set %3,
ID: %4
Information—No action required.
4050 Service has resumed a delete orphans task to %1 (%2) for Replication Set
%3, ID: %4
Information—No action required.
4051 Service has stopped a delete orphans task to %1 (%2) for Replication Set %3,
ID: %4
Information—No action required.
4052 Service has completed a delete orphans task to %1 (%2) for Replication Set
%3, ID: %4
Information—No action required.
4053 Service has started a restore task to %1 (%2) for Replication Set %3, ID: %4
Information—No action required.