American Wireless SIR-STRPNP1 - Manual (Page 17)

Streamer User Guide Streamer User Guide
• FM Modulator to On
• Audio Output Level to 50%
• Access to all skipped Shuttles (Locked streams
remain locked)
• Memory Search On
• Memory Locations are erased
• 12 Hour Clock Format
• Eastern Time Zone
• Daylight Savings Time Observed
32 33
Rotate the Encoder Knob Wheel to toggle through
the desired sleep times. When the desired time is
highlighted, press the Encoder Knob. The unit
will now turn off after the selected time has expired.
Factory Default
The Factory Default screen displays the text
Restore Default Settings with the following
adjustments: Yes/No
Upon entering this mode, rotating the Encoder
Knob toggles between the “Yes” or “No” function/
display selection. If “Yes” is chosen, the unit reverts
to the original factory settings for the following
parameters:
• All Presets revert to empty
• Auto Dimming On
• Display Contrast to 50%
• Display Mode to Auto
FAULT
Streamer does
not turn on
Check antenna
display message
Audio static or loss
of clarity
No signal on
shuttle dislplay
No sound
PROBABLE
CAUSE
Blown fuse, power cable not
properly connected
Satellite antenna not
connected
Antenna or cable is faulty
FM modulator frequency
contains static
Vehicle antenna not
connected to radio
Check for obstacles over or
around antenna
1. Audio Cables not
connected
2. Incorrect FM modulator
frequency
REMEDY
Check fuse, check
power cable
Check satellite
connection to shuttle
Contact system installer
or vendor
Switch to another FM
frequency
Check vehicle antenna
cable
Change location to
eliminate nearby
obstacles (bridge, etc.)
1. Check cables at
Shuttle and radio
2. Select another FM
modulator frequency.
Specifications
Audio Output 650mV RMS Maximum
(100-250 ohms)
Fuse 3A Slow Blow
Power Supply 10-16V, Negative Ground, DC
Dimensions 138mm W x 92mm H x 48mm D
(5 3/8” W x 3 5/8” H x 1 7/8” D)
Troubleshooting
Default Display
Channel Name
Artist Na
Song Title
0 01
No
Category 12:00pm A
Yes
Restore Defualt Settings?