HP XP P9000 Command View Advanced Edition Software - Manual (Page 235)

P9000 RAID Manager
Description
Change Pair Status Wiz-
ard
Option Command Option Operation
n/a
1. pairsplit -R
2. pairsplit -S
3. paircreate
Note: Options in
Option column apply to
paircreate only.
Recovers the P-VOL and S-VOL to
the Pair(PAIR) status when the P-VOL
is in the Simplex(SMPL) status and
the S-VOL is in the Split(SSWS)
status.
None
takeover-re-
covery (re-
create)
-c size Copy Pace
-f fence
[CTGID]
where fence
= "data",
"status",
"never",
"async"
Fence Level
-jp id JNLG ID(P)
-js id JNLG ID(S)
-nocopy No Copy
Monitoring and managing storage systems using virtual
command devices
As an alternative to using P9000 RAID Manager command devices, you can also issue commands
to storage systems over the LAN connection using virtual command devices.
NOTE:
As of 7.1.0, Replication Manager only supports monitoring and managing copy pair configuration
definitions that use virtual command devices. You cannot set up such a configuration from within
Replication Manager.
This module includes the following topics:
• About virtual command devices , page 235
• Prerequisites for virtual command device configurations , page 237
• Setting up an SVP as a virtual command device , page 238
• Using a Virtual Command Device server , page 239
• Performing user authentication for replica operations , page 240
About virtual command devices
Command devices are used to send P9000 RAID Manager commands between the pair management
server and a storage system. Command devices use the FC link (known as an in-band connection).
Virtual command devices allow you to perform the same operations using the LAN (known as an
out-of-band connection). This configuration uses either the Service Processor (SVP) of the storage
system, or a dedicated P9000 RAID Manager server (known as a Virtual Command Device server).
User Guide 235