HP ProLiant ML310 G3 Server - Manual (Page 25)

To launch HPSUM:
1. For Windows Server 2008 R2 operating system, click Start, and then select All
Programs>Pre-Install Features>HP Service Pack for Proliant.
For Windows Server 2012 operating system, Press button from the keyboard and right
click anywhere in the Start page, then click All Apps>Pre-Install Features>HP Service Pack for
ProLiant.
2. Follow the on-screen instructions when the setup program is launched.
To manually launch the setup program:
1. Click Start>Run.
2. Enter the following path in the text box:
C:\HPSUM\SETUPEX.EXE
3. Click OK.
4. After the setup program is launched, follow the on-screen instructions.
Configuring array controllers
If an array controller was purchased with the server, run the online ACU to set up the remaining
physical drives for use.
IMPORTANT: Microsoft® Internet Explorer is required to run the ACU. Internet Explorer is used
to interface with the array controller. For the page to display properly, the server IP address must
be included in the trusted sites list. Internet Explorer must be restarted after adding the IP address
to the trusted sites list for the settings to take effect.
To configure array controllers:
1. For Windows Server 2008 R2 operating system, click Start, and select All Programs>HP
System Tools>HP Array Configuration Utility>HP Array Configuration Utility.
For Windows Server 2012 operating system, Press button from the keyboard and right
click anywhere in the Start page, then click All Apps>HP System Tool>HP Array Configuration
utility>HP Array Configuration utility.
2. Select whether you want to enable remote administration when prompted.
3. Click OK.
4. When prompted for the Web-based Management password, enter the credentials for either
the local administrator account or a local user account in the following format:
domain name\login name
5. Configure the remaining physical drives into logical drives, and run Disk Administrator to
partition and format the additional drive space.
For more information about using the ACU, see the HP Online Help .
Using Management Agents
The Management Agents for servers are installed during the setup process. For more information
about the Management Agents, see the
HP Insight Management Agents User Guide .
Configuring array controllers 25