HP Integrity NonStop J-Series - Manual (Page 22)

Operation
5344-2SE Tape Drive Installation and User’s Guide — 546010-001
3 -4
Front Panel
TAPE FLASHES
The drive believes the current
tape or the tape just ejected is
faulty.
Unload the tape cartridge. Make
sure that you are using the correct
format cartridge.
Reload the cartridge. If the Tape
LED still flashes or starts flashing
during the next backup, load a
new or known good cartridge.
If the Tape LED is now off, discard
the ’suspect’ tape cartridge. If it is
still on, call for service.
DRIVE FLASHES
The drive mechanism has
detected an error.
Load a new cartridge. If the error
persists, power cycle or reset the
drive.
If the Drive LED remains on, call
for service.
DRIVE, TAPE, AND
READY FLASH
There is a firmware download
problem. Insert a cartridge to clear the LED
sequence. If the condition persists,
call for service.
Table 3-1. Tape Drive LEDs
LED Sequence Cause Action Required