Supported firmware revisions, Supported hardware – HP Fusion ioFX 410GB PCIe Accelerator User Manual
Page 8
Introduction 8
CAUTION:
Version 3.1.1 of the driver software is not backward-compatible. When you install
version 3.1.1, you cannot revert to any previous version.
IMPORTANT:
All operating systems must be 64-bit architecture.
NOTE:
IO Accelerators cannot be used as hibernation devices.
The following scenarios are supported:
•
Using the IO Accelerator as a VMFS datastore within the hypervisor, and then sharing that storage with
guest operating systems. Guest operating systems can be 32-bit or 64-bit architecture because they are
not directly using the IO Accelerator.
•
Using PCI pass-through to enable a virtual machine to directly use the IO Accelerator. Only supported
operating systems can use the device.
NOTE:
PCI pass-through is currently supported on Windows® and Linux operating systems that
are supported by HP. For installation instructions and a list of supported operating systems, see
the HP IO Accelerator Windows User Guide or the HP IO Accelerator Linux User Guide.
NOTE:
If you are passing the devices through the system, you do not have to install the IO
Accelerator driver on an ESX or ESXi system. Install the driver on the guest system. Install the driver
only if you plan to create a VMFS on the devices. For more information, see "Working with IO
Accelerators and VMDirectPathIO (on page
)."
NOTE:
For best results, HP recommends running the latest Service Pack of a release.
Supported firmware revisions
VMware ESX version
IO Accelerator
software
IO Accelerator
firmware
Comments
VMware ESX 4.0
2.2.3 or 2.3.1
101583_6 or 101971_6
(2.3.1)
Update 1; 101583 is
compatible with both software
versions.
VMware ESXi 4.0
Not supported
Not supported
ESXi 4.0 is not supported.
VMware ESX 4.1
2.2.3 or 2.3.1
101583_6 or 101971_6
(2.3.1)
Version 101583 is
compatible with both software
versions
VMware ESXi 4.1
2.3.1
101583_6 or 101971_6
(2.3.1)
HP recommends 101971_6
firmware
NOTE:
HP StorageWorks IO Accelerators require firmware version 101971_6 or 101583. HP
PCIe IO Accelerators also support firmware version 101971_4.
Supported hardware
HP IO Accelerator for BladeSystem c-Class