HP Integrity NonStop J-Series User Manual
Page 203
Command Interpreter
HP AutoSYNC User’s Guide—522580-018
8-109
SYNCHRONIZE
By default NETWORKSECURE is enabled and file security is changed as
follows:
The default is NETWORKSECURE, but the SECURE option overrides
NETWORKSECURE.
NOSAFEGUARD | NO NOSAFGUARD
specifies that the Safeguard ACL for a source Enscribe disk file is not
propagated to the destination when the file is synchronized. A warning is
written to the log file to notify the user that the Safeguard setting for the source
file has been turned off on the destination.
The default is NO NOSAFEGUARD and the ACL for a source file is
propagated to the synchronized destination file.
RECOVER[Y] | NO RECOVER[Y]
enables or disables the recovery option.
If recovery is enabled, AutoSYNC saves a copy of an existing destination file to
an archive subvolume with the name of the Autosync MapDB before it restores
a later copy of the file. If a failure occurs during the synchronization and the file
is corrupted, the archived copy is recovered and replaces the corrupted file.
This option overrides the global parameter [AUTO]SYNCRECOVER.
By default, recovery is enabled.
RENAMEO[PEN]
specifies that destination unaudited files that are opened for shared READ
access or running object files are to be renamed to allow AutoSYNC to replace
them.
The syncuser must have PURGE privileges to the destination file for the
RENAME to succeed.
Both the old and new file names are recorded in an AutoSYNC index file called
AAINDEX, located in the MapDB subvolume.
The renamed files are named AAnnnnnn, where nnnnnn is a sequence
number, and are placed in the same subvolume name as the AutoSYNC
Source file
security
Destination file
security
“A”
“N”
“G”
“C”
“O”
“U”
“-”
“-”