HP Modular Cooling System - Manual (Page 22)

Web interface 22
• General menu (on page 28 )
• Network menu (on page 30 )
• Management menu (on page 31 )
• Accounts menu (on page 36 )
• Configuration Save/Restore menu (on page 37 )
These menu options enable the Admin to configure the settings for the management module. The Setup tab
and all menu options are not available to User accounts.
Cooling System
Click Cooling System in the left navigation frame to access the Cooling System screen. This screen enables
the Admin to configure cooling system settings for the management module.
The Cooling System screen contains the following:
• Intake Temp tab (on page 22 )
• Alarms/Warnings tab (on page 24 )
• Advanced tab
• Timers tab (on page 28 )
Intake Temp tab
This screen enables the Admin to change server intake temperature settings for the management module.
NOTE: The following screen is the same for either MCS-100 or MCS-200 units.
To change the server intake temperature settings:
1. In the Server Intake Temperature Set Point field, enter a server intake temperature set point .
2. In the High Temperature Threshold field, enter a maximum air temperature at which a critical alarm is
issued and a trap is sent if the server intake temperature exceeds the value listed.
3. In the Warning Temperature Threshold field, enter an air temperature at which a warning is issued and
a trap is sent if the server intake temperature exceeds the value listed.