Introduction, Set up your web-connected printer, Introduction set up your web-connected printer – HP Designjet T1300 ePrinter User Manual
Page 32
Introduction
This chapter describes various printer settings that the printer administrator may wish to control as soon
as a new printer is assembled and ready for use.
Set up your Web-connected printer
Your printer can connect to the Internet to benefit from various Web Services (see also
):
●
Automatic firmware updates
●
Use HP Designjet ePrint & Share from the front panel
●
Use HP ePrint to print by email
To set up your printer for Web Services, please follow these steps, explained in more detail below:
1.
Make sure that your printer is correctly connected to the Internet.
2.
Run the Connectivity Wizard: At the front panel, press
, then
, then Connectivity >
Connectivity wizard.
If you cannot find the Connectivity Wizard in the menu, please update your firmware and then try
again.
If the Wizard downloads new firmware, the printer may need to restart.
TIP:
When the Wizard displays your printer code and email address, you are recommended to
make a note of them.
3.
Create an HP Designjet ePrint & Share account when prompted, or later,
. HP Designjet ePrint & Share saves copies of all your print jobs in the cloud so
that you can reprint and share them from almost anywhere, even from smartphones and tablet
computers.
4.
Activate your account by clicking the activation link that you will receive by email.
TIP:
If you don’t see the message, remember to check your junk email folder.
5.
This is an optional step: If you are the printer administrator, log in at the HP ePrint Center
o customize your printer’s email address or manage
eprinter security for remote printing.
Congratulations, you now have completed Web Services setup. HP ePrint and HP Designjet ePrint &
Share are ready to use.
For the latest information, support, and terms of use of the HP ePrint Center and HP Designjet ePrint &
Share, see their respective websites
and
.
24
Chapter 3 Setting up the printer
ENWW