HP Designjet T1300 ePrinter - Manual (Page 34)

● Firmware update information: Information about the firmware currently installed
● Firmware update history: A list of firmware versions that have been installed in the printer. It
is usually possible to reinstall the version immediately before the version that is currently installed,
if you have some problem with the current version.
Set remote printing preferences
At the front panel, press , then , then Setup > Printing preferences to define the default
properties of jobs sent to your printer from remote locations.
● Printer margins: Choose between Clip from contents and Add to content.
● Color: Choose between Color and Grayscale printing.
● Print quality: Choose between Best, Normal, and Fast.
● Roll: Choose between Roll 1, Roll 2, and Save paper, which automatically chooses the
narrowest roll on which the print will fit.
● Jobs: Choose between On hold and Direct print. By default, jobs from the cloud are On
hold. If you choose Direct print, the front panel will not ask for permission before printing.
Set HP Designjet ePrint & Share preferences
At the front panel, press , then , then Setup > Printing preferences to define the default
properties of the jobs sent to your printer from HP Designjet ePrint & Share.
● Size: Choose between resizing the print to a percentage of its original size, or to fit a particular
paper size. The default is 100% of its original size.
● Color: Choose between Color and Grayscale printing.
● Print quality: Choose between Best, Normal, and Fast.
● Roll: Choose between Roll 1, Roll 2, and Save paper, which automatically chooses the
narrowest roll on which the print will fit.
● Rotation: Choose between any multiple of 90°, or Automatic, which rotates the print
automatically if doing so will save paper.
Paper suitability options (T1300 series)
Paper mismatch action
If the paper currently loaded in the printer is not suitable for a particular job, the printer can either put
the job on hold until some suitable paper is loaded, or it can ignore the problem and print the job on
the unsuitable paper. There are several ways in which the loaded paper may be considered unsuitable:
● The paper type is not as specified for the job
● The paper source (roll 1, roll 2 or sheet) is not as specified for the job
● The paper size is smaller than specified for the job
26 Chapter 3 Setting up the printer ENWW