Load a roll into the printer – HP Designjet T1300 ePrinter User Manual
Page 49
5.
Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the
spindle showing the correct orientation.
NOTE:
From the back of the printer, the blue stopper is inserted into the right-side holder.
Ensure both ends of the roll are as close to the spindle stops as possible.
6.
Put the blue paper stop on to the open end of the spindle, and push it towards the end of the roll.
7.
Ensure the blue paper stop is pushed in as far as it goes; until both ends are against the stoppers.
If you are a regular user of different paper types, you can change rolls more quickly if you preload rolls
of different paper types on different spindles. Extra spindles are available for purchase, see
.
Load a roll into the printer
To start this procedure, you must have a roll loaded on the spindle. See
TIP:
If you have a T1300 series printer, do not try to open both roll covers at once; this may cause
problems. Always close one cover before opening the other.
ENWW
Load a roll into the printer
41