HP 8.20q Fibre Channel Switch - Manual (Page 38)

38 Getting Started
11. Complete the Set the Switch Default Zoning dialog box as follows:
a. In the Default zone set name box, enter a new name for your configuration.
b. To exclude a storage port from the zone, clear the check box next to the port name. To include a
storage port in the zone, select the check box next to it.
c. To save the new switch default zoning setup, click OK. To stop the switch zoning changes, click
Cancel.
The New Switch Setup dialog box shows a check mark next to the third step, “Set switch administrator
password,” ( Figure 18 ) indicating that you have completed that task.
Figure 18 Third step of New Switch Setup completed
12. Click Close to close the New Switch Setup dialog box for this switch.
13. If SAN Connection Manager detects another unconfigured switch, the New Switch Setup wizard opens
again for that switch and guides you through its setup.
After you have either completed all the steps required in the New Switch Setup procedures (
step 4
through step 9 ), or opted not to set up the switch at this time, the Welcome… Configure Your SAN
dialog box ( Figure 19 ) appears.
Figure 19 Welcome… Configure Your SAN dialog box