HP LaserJet 4100 Multifunction Printer series User Manual
Page 90
88 Chapter 8 – Problem solving
EN
INTERRUPT COPY
JOB
Do you want to interrupt the job currently being copied? Yes/No.
If the job is interrupted, it will resume as soon as your job is completed.
MANUALLY FEED
[TYPE] [SIZE]
Load the requested media into Tray 1. Press
S
TART
if the desired media is already loaded in
Tray 1.
MEMORY FULL
STORED DATA LOST
There is no available memory. The current job might not print correctly and some resources
(such as downloaded fonts or macros) might have been deleted.
MEMORY SETTINGS
CHANGED
The product changed its memory settings because it did not have enough memory to use the
previous settings for I/O Buffering and Resource Saving. This usually occurs after removing
memory from the product, adding a duplexer, or adding a printer language.
MEMORY SHORTAGE
JOB CLEARED
The product did not have enough memory to print the entire job. The remainder of the job will not
print and will be cleared from memory. Press
S
TART
to continue.
MEMORY SHORTAGE
PAGE SIMPLIFIED
The product had to compress the job to fit it in available memory. Some data loss might have
occurred. Press
S
TART
to continue.
The print quality of these pages might not be acceptable. Reduce the complexity of these pages
and reprint them.
NON HP TONER
CARTRIDGE
DETECTED
alternates with
PRESS START TO
CONTINUE
The product has detected that the toner cartridge is not an HP toner cartridge. If you believe you
purchased an HP toner cartridge, call the HP fraud hotline. Any product repair required as a result
of using non-HP toner is not covered under the product warranty.
OFFLINE
Press
S
TART
to bring the product online.
OUTPUT BIN FULL
alternates with
CLEAR PAPER FROM
[BINNAME]
The specified output bin is full and must be emptied for printing or copying to continue.
PAPER WRAPPED
AROUND FUSER
Turn the product off to prevent the media from wrapping more firmly around the fuser. Open the
top cover and remove the toner cartridge. Remove all visible media. If you cannot locate the media,
leave product turned off and remove the fuser to reach the media (see
).
PERFORM ROUTINE
MAINTENANCE
To ensure optimal print quality, the product prompts you to perform routine maintenance every
200,000 pages. To order a printer maintenance kit, see
“Ordering information” on page 125
. For
information about maintenance, see
“Performing preventative maintenance” on page 76
.
PRINTER LANGUAGE
NOT AVAILABLE
A print job requested a printer language that does not exist in the printer. The job does not print
and is cleared from memory.
Print the job using a driver for a different printer language, or add the requested language to the
product (if available). Press
S
TART
to continue.
PROCESSING AUTO
CLEANING PAGE
The auto cleaning page is in process. This can take up to 2.5 minutes.
PROCESSING
CLEANING PAGE
The manual cleaning page process is underway. This can take up to 2.5 minutes.
SCAN AHEAD
Scanning pages. Your document is being scanned now. It will print when the current job is finished.
SCANNER COVER
OPEN
The ADF cover on top of the scanner glass is open, preventing the scan from taking place. Close
the cover and resume the operation.
Control panel messages (continued)
Message
Explanation or recommended action