HP LaserJet 4100 Multifunction Printer series - Manual (Page 80)

78 Chapter 8 – Problem solving EN
Clearing jams
If the control panel display shows a jam message, look for media in the locations
indicated in the figure on the next page, and then see the procedure for clearing the jam.
You might need to look for media in locations other than those indicated in the jam
message. If the location of the jam is not obvious, look first in the top cover area
underneath the toner cartridge.
When clearing jams, be very careful not to tear the media. If a small piece of media
remains in the product, it could cause additional jams. If jams are a recurring problem,
see
“Solving repeated jams” on page 85 .
Note The top cover of the product must be opened and then closed to clear a jam message.
If a jam occurs in the optional power envelope feeder, see the installation and use
documentation that accompanied the product.
Jam locations
1 Top cover and toner cartridge area
2 Optional power envelope feeder
3 Input tray areas
4 Optional duplex printing accessory
5 Output bins (top and rear)
6 Fuser area
7 ADF
Note Loose toner might remain in the product after a jam and cause output quality problems.
These should clear up within a few pages.
1
6
2
4
3
5
5
7
Front Back