HP Deskjet 932c Printer - Manual (Page 17)

11
Beyond the Basics 2
Setup Tab Features Tab
HP print settings to choose Guidelines to remember
Setup Tab
- Paper Type: Choose
HP Photo Paper
- Print Quality: Choose Best
- Paper Size: Choose appropriate paper size
Features Tab
- Orientation: Choose appropriate orientation
- Two-Sided Printing: Unchecked
• For best results use HP Photo Paper.
• The photo needs to be in electronic (digital) form,
before you can print it. Take a digital picture, scan a
photo, or have your local camera shop provide an
electronic file of your photo.
• After selecting your paper type, choose the
appropriate paper size from the pull-down menu.
• You may be able to increase photo printing speed by
enabling Hardware ECP. Open the HP DeskJet
Toolbox. Click the
Configuration tab and check
Attempt to Use Hardware ECP. Apply your changes
and print your photo.
Setup Tab
- Paper Type: Choose appropriate paper type
- Print Quality: Choose
Normal or Best
- Paper Size: Choose appropriate card size
Features Tab
- Orientation: Choose appropriate orientation
- Two-Sided Printing: Unchecked
• Align the card edges before inserting the cards.
• If you get an “out of paper” message, make sure that
the photo paper or other small media is positioned
properly in the IN tray. Place the media on the right
side and towards the printer. The IN tray should be
pushed in so that the paper length guide can hold the
media in place.
• If your media is smaller than 100 x 148 mm (4 x 5 5/8
inches, use the single envelope slot to load your
media one sheet at a time.