HP ProLiant BL20p G4 Server-Blade - Manual (Page 17)

Operations 17
6. Remove the access panel.
Install the access panel
1. Place the access panel on top of the server blade, allowing it to extend past the rear of the server
approximately 10 mm (0.39 in).
2. Slide the access panel forward to lock, and tighten the captive screw to secure the access panel to
the server.
Remove the air baffle
To remove the component:
1. Power down the server blade (on page 15 ).
2. Remove the server blade (on page 16 ).
3. Remove the access panel (on page 16 ).